How to use mold release agent for die casting process?

Die-casting release agent mostly using water-based version, should be considered first in the use of release agent, spray or brush, the thickness of the coating is not too thick but even, after diluent volatile then close mold for die casting, thereby avoiding the cavity or the increased amount of gas chamber pressure and the possibility of casting blowholes, avoid due to the increase of the gas to form a high backpressure, make forming difficult.

In the process, the exhaust system should be wrongly at any time to avoid the loss of the exhaust system due to the blockage of the release agent. At the same time, it should avoid the accumulation of the release agent at the turning and convex angles, so as to avoid the unclear outline of the die casting.

Is water quality important for metalworking fluids？

Yes, water makes up approximately 90% of the sump volume. As part of our service, we provide a water analysis at no cost to our customers. Please contact your rep to make use of this service

1.The lubrication performance of semi synthetic cutting fluid is relatively poor, and the machining effect is poor. 

2.Semi synthetic cutting fluid should be better than full synthetic cutting fluid in dimensional accuracy and product finish.